| 1. | A method of simulating a slave device with i2c bus
总线从器件的一种方法 |
| 2. | Ide bus connector 1 slave device
Ide总线连接器1从属设备 |
| 3. | Ide bus connector 0 slave device
Ide总线连接器0从属设备 |
| 4. | Slave device searching algorithm based on master - and slave - device coordination
基于主从站配合的从站搜索算法 |
| 5. | Based on the hardware , we have finished software in the slave device and supervision software on the master pc
在硬件设计的基础上，对系统进行了软件设计，软件部分包括下位机单片机程序的设计和上位机监控软件的设计。 |
| 6. | For this reason , the master device could conceivably start transmissions before the slave device has finished receiving data , leading to a failure in communications
由此可知，主设备可能会在从设备接受数据结束之前便开始发送数据，从而导致通信失败。 |
| 7. | The writer achieves management information system and researches the field bus to the certain extent , further more , brings forth the design method to the profibus - dp intelligent slave device
作者在完成了管理信息系统后还对现场总线做了一定的研究，比较深入的讨论了profibus - dp这种总线的智能从站接口的设计方法。 |
| 8. | Due to the measurement system is distributed and is made up of multiple host devices and multiple slave devices , how to successfully solve the possible communication conflict by introducing a retreat algorithm are expounded
本文重点对基于rs - 485总线的多点对多点的分布式通信网络进行了研究,通过一种退避算法和通信协议成功解决了可能出现的通信冲突。 |
| 9. | And you should use only one drive per ide channel to avoid sluggish performance - a slave device , especially if it s also part of the raid - 0 array , will slow things down so much as to nearly eliminate any raid - 0 performance benefit
同时，为了避免降低性能，每个ide通道上只应连接一个驱动器- -从属设备（尤其是当它也是raid - 0阵列的一部分时）对速度的负面影响几乎会抵消raid - 0的全部性能优势。 |
| 10. | After the host computer sends the broadcast command to order measurement operation , all slave devices will start to sample the input signals synchronously . when the sampling operation has finished , devices installed on the capacitive equipments will calculate the phase angle difference ( oi ) between leakage current and the reference voltage signal , and devices installed on pt will calculate the phase angle difference between secondary voltage and the reference voltage signal ( ou )
我们把一个50hz的交流基准电源引到每台下位机内，主机发布一个广播命令要求pt和电容型设备上的监测装置同时采样，电容型监测装置计算出泄漏电流和基准源之间的相位差_ ( oi ) ， pt上的装置计算出二次电压与基准源之间的相位差_ ( ou ) 。 |
